Linux version 2.3.49 (root@vaio.net) (gcc version egcs-2.91.66 19990314/Linux (egcs-1.1.2 release)) #3 Fri Mar 3 23:16:07 PST 2000
e820: 0009f800 @ 00000000 (usable)
e820: 00000800 @ 0009f800 (reserved)
e820: 00017c00 @ 000e8400 (reserved)
e820: 0fef0000 @ 00100000 (usable)
e820: 0000f800 @ 0fff0000 (ACPI data)
e820: 00000800 @ 0ffff800 (ACPI NVS)
e820: 00080000 @ fff80000 (reserved)
Scan SMP from c0000000 for 1024 bytes.
Scan SMP from c009fc00 for 1024 bytes.
Scan SMP from c00f0000 for 65536 bytes.
Scan SMP from c009f800 for 4096 bytes.
On node 0 totalpages: 65520
zone(0): 4096 pages.
zone(1): 61424 pages.
zone(2): 0 pages.
mapped APIC to ffffe000 (01484000)
Initializing CPU#0
Detected 496313075 Hz processor.
Console: colour VGA+ 80x25
Calibrating delay loop... 494.80 BogoMIPS
Memory: 254888k/262080k available (1343k kernel code, 6804k reserved, 97k data, 188k init, 0k highmem)
Buffer-cache hash table entries: 16384 (order: 4, 65536 bytes)
Page-cache hash table entries: 65536 (order: 6, 262144 bytes)
CPU: Intel Pentium III (Coppermine) stepping 01
Checking 386/387 coupling... OK, FPU using exception 16 error reporting.
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
mtrr: v1.36 (20000221) Richard Gooch (rgooch@atnf.csiro.au)
PCI: PCI BIOS revision 2.10 entry at 0xfd99e
PCI: Using configuration type 1
PCI: Probing PCI hardware
PCI: Interrupt Routing Table found at 0xc00fdf40 [router type 8086/122e]
Limiting direct PCI/PCI transfers.
isapnp: Scanning for Pnp cards...
isapnp: No Plug & Play device found
Linux NET4.0 for Linux 2.3
Based upon Swansea University Computer Society NET3.039
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 2048 buckets, 16Kbytes
TCP: Hash tables configured (established 16384 bind 16384)
apm: BIOS version 1.2 Flags 0x03 (Driver version 1.13)
Starting kswapd v1.6
Serial driver version 4.92 (2000-1-27) with MANY_PORTS SHARE_IRQ SERIAL_PCI ISAPNP enabled
pty: 256 Unix98 ptys configured
Uniform Multi-Platform E-IDE driver Revision: 6.30
PIIX4: IDE controller on PCI bus 00 dev 39
PIIX4: not 100% native mode: will probe irqs later
hda: TOSHIBA MK1214GAP, ATA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
hda: TOSHIBA MK1214GAP, 11513MB w/0kB Cache, CHS=1467/255/63
Partition check:
 hda: hda1 hda2 < hda5 hda6 hda7 hda8 >
Floppy drive(s): fd0 is 1.44M
floppy0: no floppy controllers found
scsi : 0 hosts.
scsi : detected total.
[drm] Initialized tdfx 0.0.1 19991009 on minor 63
Linux PCMCIA Card Services 3.1.11
  options:  [pci] [cardbus] [pm]
Adding cardbus controller 0: Ricoh Co Ltd RL5c475
Yenta IRQ list 0cb8, PCI irq0
Socket status: 30000419
Intel PCIC probe: not found.
Databook TCIC-2 PCMCIA probe: not found.
VFS: Mounted root (ext2 filesystem) readonly.
Freeing unused kernel memory: 188k freed
Adding Swap: 130748k swap-space (priority -1)
eepro100.c:v1.09j+LK1.0 Feb 13, 2000  Linux Kernel Team  http://cesdis.gsfc.nasa.gov/linux/drivers/eepro100.html
PCI: Enabling bus mastering for device 00:0b.0
eth0: OEM i82557/i82558 10/100 Ethernet at 0xd0826000, 08:00:46:05:E4:C2, IRQ 9.
  Board assembly 100001-001, Physical connectors present: RJ45
  Primary interface chip i82555 PHY #1.
  General self-test: passed.
  Serial sub-system self-test: passed.
  Internal registers self-test: passed.
  ROM checksum self-test: passed (0x04f4518b).
  Receiver lock-up workaround activated.
cs: IO port probe 0x1000-0x17ff: clean.
cs: IO port probe 0x0100-0x04ff: excluding 0x170-0x177 0x220-0x22f 0x330-0x337 0x370-0x37f 0x388-0x38f 0x398-0x39f 0x4d0-0x4d7
cs: IO port probe 0x0a00-0x0aff: clean.
cs: memory probe 0xa0000000-0xa0ffffff: clean.
aha152x: processing commandline: ok
aha152x: BIOS test: passed, detected 1 controller(s)
aha152x: resetting bus...
aha152x0: vital data: rev=1, io=0x340 (0x340/0x340), irq=3, scsiid=7, reconnect=enabled, parity=enabled, synchronous=disabled, delay=100, extended translation=disabled
aha152x0: trying software interrupt, ok.
scsi0 : Adaptec 152x SCSI driver; $Revision: 2.0 $
scsi : 1 host.
  Vendor: Nikon     Model: LS-2000           Rev: 1.31
  Type:   Scanner                            ANSI SCSI revision: 02
Detected scsi generic sga at scsi0, channel 0, id 5, lun 0